Ruckus 9.8 or above (ZD managed)

You are here:
Estimated reading time: 1 min

IMPORTANT: This guide is for the Ruckus ZoneDirector release 9.8 or above. If you’re using release 9.6 or 9.7 please select Ruckus AP (ZD v9.7 or below) in your portal and use that guide instead.

Open a web browser and log in to your Ruckus ZoneDirector

Click on “Configure” on the top menu

Click on “AAA Servers” on the left menu and then “Create New“. Configure with the below settings:

  • Name: Guest WiFi
  • Type: RADIUS
  • Auth Method: PAP
  • Backup Backup RADIUS support: Ticked
  • First Server IP Address: *insert radius_server_ip here*
  • Port: 1812
  • Shared Secret: *insert radius_secret here*
  • Confirm Secret: as above
  • Second Server IP Address: *insert radius_server2_ip here*
  • Port: 1812
  • Shared Secret: *insert radius_secret here*
  • Confirm Secret: as above

Press OK to save

Please note: You need to be running HiveManager 6.4r1 or above in order to continue. Earlier versions are not supported.

Log in to your HiveManager web interface

Click on Configuration at the top and then on Guided Configuration on the left.

Under Choose Network Policy click New and configure with:

Click on Create to continue

Next to SSIDs click Choose. Click on New and configure with:

All other settings can be left at their defaults.

Click Save and then OK

Next, click on <Captive Web Portal> and choose New. Configure with:

Under Captive Web Portal Login Page Settings:

Under Captive Web Portal Success Page Settings:

Under Optional Advanced Configuration:

Under Walled Garden:

IMPORTANT: You will need to add the below entries one by one. Click on New, enter the domain and then click Apply. Repeat this until you have all domains in the list below.

portals.hostspot.mx

Click Save
Next, click on <RADIUS Settings> and choose New. Configure with:

Under Add a New RADIUS Server configure with:

Click Apply to add, and then click on New to add another:

Click Apply again, and then click on Save

Under User Profile click on Add/Remove.

Select default-profile and click Save

Further down the page, beside Advanced Settings click Edit

Click on Service Settings and beside ALG Services click the Plus (+) icon Configure with:

Click on Save and then Save again at the top right. The screen should now look like:

Finally, click on Continue at the top right.

You are now asked which of your access points you wish to push the new settings to (typically all your access points). Select all that apply, and click Update > Update Devices

Click Update.

Was this article helpful?
Dislike